TRSP5011A General Descriptions:
    TRSP5011A series are 4-bits micro-controller which could play 4 channel melody or 4 channel ADPCM with PWM direct drive circuit. PWM resolution is 8/10/12 bits. They includes a low cost, high performance CMOS micro-processor. The clock frequency of this up is typically 8.192 (±3%) MHz. This chip operates over a wide voltage range of 2.0V~5.5V. It contains program ROM (PROM) and data ROM (DROM) inside. The maximum program ROM is 4K words and maximum data ROM size is 33K byte. The maximum working SRAM is (64+2) nibbles. It is provided with total 4 software programmable I/O Ports.
TRSP5011A Features:
  Operating voltage: 2.0V to 5.5V
  MCU Operation frequency: 8.192MHz
  Memory Size
    -Program ROM size: 4K*12-bits OTP type
    -Data ROM size: 33K*8-bits OTP type
    -SRAM size: 64*4 bits
    -User register: 2*4 bits
  Wakeup function for power-down mode:
    -HALT mode wakeup source: Port A can wake-up from HALT mode to NORMAL mode and executing wake-up sub-routine program.
  4 input/output pins: Port A can be defined as input or output port bit by bit.
  Three reset condition:
    -Low voltage reset. (LVR = 2.0V)
    -Power on reset.
    -Watch dog timer overflow.
  One internal interrupt sources:
    -PWM interrupt.
  WDT
    -Watch dog timer, can enabled/disabled by option.
    -WDT period is 256*256*16/Fsys. (WDT period is 0.13 sec for system clock=8.192MHz)
Audio output:
    -Support PWM or DAC mode by option.
    -Support 8/10/12 bits.
  Support option set for pull down resistor 1M, 50K or 220K Ohm, low voltage reset…etc.
  Oscillator fuse option ±3%, temperature & voltage compensation.
  Support security option (1 bit) for read inhibition.
  Support 16-levels LVD function.
TRSP5011A provides SOP8 package:

TRSP5011A Block Diagram:

TRSP5011A Speaker wakeup structure:

TRSP5011A The Application Circuit:

TRSP5011A DAC Selected by option:

Notice:
1. Regarding recording or remote car applications, please reference application note on web site.
2. C1 : 47 uF ~ 100 uF(depends on applications), C2:0.1 uF
3. DAC Applications circuit not support PWM wakeup function.
4. DAC Applications, please reference application note on web site.
			
		
















